Hi! Thank you for purchasing a Kyria. If you're reading this, you'll have purchased a Kyria revision 2.0+ kit and are looking for guidance.
The build guide is currently under construction. In the meantime, please follow the revision 1.0 build guide, with the following considerations:
When using a Kyria rev2.0 only:
- This does NOT apply to the Kyria rev2.1 or later, it applies only to the 2.0 revision.
- ⚠ The microcontroller should be soldered with its components facing up. Please ensure you solder it with the components facing up! It is very hard to undo this.
When using a Kyria rev2.0 or 2.1:
- If using a nice!nano: solder the power switch before soldering the reset button and TRRS jack, so that you can still easily reach the pads. You should also skip soldering the D26 diode as it is not needed and will prevent the controller from entering deep sleep mode.
- There are no OLED Display jumpers to solder, you can safely skip this step.
The text version of the build guide will be available soon. Pictures will be added later. Thank you for your patience!